Search for Dimensions and CAD of Drive Products Inverters-FREQROL

[Copyright]

Mitsubishi Electric Corporation

[2D CAD]

(1) System requirements

• - Read the extracted DXF or DWG file with the CAD software used.
• - We have confirmed that DXF or DWG files can be read with the following CAD software.

(2) Layer configuration

• The layer configuration of this CAD data is as follows.
• (The layers used depend on the model.)
• The colors may differ depending on the CAD software used.

[3D CAD]

(1) Precautions for downloading

• - The model name in the name of the downloaded zip compressed file may not match the actual model name.
• - Decompress the downloaded zip compressed file before using it.
• - The model name in the file name may not match the actual model name.
• For products with the same outline dimensions, the CAD data file of the representative model is used as the common file.
• - When the model name in the file name of the decompressed 3D CAD data is that of a different model with the same dimensions, change the model name in the file name in single-byte lower-case characters.

(2) 3D CAD data formats

• * If the IGES file cannot be read properly, try reading the STEP file instead.

[CAD data models]

• - To reduce data capacity, the drawings are partially simplified.
• - The details that are not necessary for the layout planning, such as chamfering, corner radius, draft angle, screw thread, and screw head, are omitted.
• - Use the CAD data models only for design planning.
• - The CAD data may be changed without notice due to product modification or other reasons.
• - The CAD data does not guarantee the specifications of our products.
• We will not be liable for any loss or damages caused by using the CAD data.

Downloading the 2D or 3D CAD data constitutes acceptance of the above.